CTS V6-3.2L VIN N (2003)
Rear Knuckle Alignment Link: Service and Repair
Adjustment Link Replacement
Removal Procedure
1. Raise and support the vehicle. Refer to Vehicle Lifting.
2. Remove the tire and wheel.
3. Remove the adjustment link to knuckle mounting bolt.
4. Remove the adjustment link to frame mounting bolt.
5. Remove the adjustment link from the vehicle.
Installation Procedure
1. Install the adjustment link to the vehicle.
2. Install the adjustment link to knuckle mounting bolt.
Notice: Refer to Fastener Notice in Service Precaution.
3. Install the adjustment link to frame mounting bolt.
^
Tighten the bolts to 175 Nm (129 ft. lbs.).
4. Install the tire and wheel.
5. Lower the vehicle.
6. Adjust the rear toe.
