CTS V6-3.2L VIN N (2003)
6. Install the J45012 to the drive flange.
Notice: Refer to Fastener Notice in Service Precautions.
7. While holding J45012 Install a NEW drive flange nut using J29873.
Tighten the drive flange nut to 57 Nm (42 ft. lbs.).
8. Remove J45012 from the drive flange.
9. Remove the mechanics wire (2) securing front propeller shaft (1) to the shift control lever (3).
10. Install the propeller shaft coupler (1) to the transmission flange.
11. Install the exhaust system.
