CTS V6-3.2L VIN N (2003)
Seals and Gaskets: Service and Repair
Seal Replacement - Torque Converter
Seal Replacement - Torque Converter
Tools Required
^
J8092 Universal driver Handle
^
J44766 Seal Installer
^
J45000 Seal Remover
Removal Procedure
1. Remove the transmission torque converter.
2. Remove and discard the torque converter seal bolts.
3. Remove the torque converter seal using J45000.
Installation Procedure
1. Assemble J8092 onto J44766.
2. Install the torque converter seal onto the tool before installing into the case to prevent damage to the seal.
Important: Align the torque converter seal with the bolt holes.
3. Install the torque converter seal into the torque converter housing.
Notice: Refer to Fastener Notice in Service Precautions.
4. Install the torque converter seal bolts.
Tighten the NEW torque converter seal bolts to 3.6 Nm (31.9 inch lbs.).
5. Install the transmission torque converter.