CTS V6-3.2L VIN N (2003)
Control Module: Service and Repair
Transmission Control Module Programming Procedure
Transmission Control Module Programming Procedure
TCM Programming Procedures
1. The Transmission Control Module (TCM) must be programmed with the proper software/calibrations. Ensure that the following conditions exist
in order to prepare for TCM programming:
^
The battery is fully charged.
^
The ignition switch is in the RUN position.
^
The Techline equipment cable connection at the Data Link Connector (DLC) is secure.
2. Program the TCM using the latest software matching the vehicle. Refer to up-to-date Techline equipment user instructions.
3. If the TCM fails to program, proceed as follows:
^
Ensure that the TCM connection is OK.
^
Inspect the Techline equipment for the latest software version.
^
Attempt to program the TCM. If the TCM still cannot be programmed properly, replace the TCM.