CTS V8-5.7L VIN P (2004)
13. Connect the passenger/RF side impact module and seat belt pretensioner yellow connector to the vehicle harness yellow connector (1) located
under the front of passenger seat.
14. Install both CPA locks to the RF side impact module and pretensioner yellow connector (1).
15. Connect the passenger/right roof rail module yellow connector (3) to the vehicle harness yellow connector (2).
16. Install the CPA (1) to the right roof rail module yellow connector (2).
17. Install the right rear sail panel.
18. Install the SIR fuse into the right rear fuse center (1).
19. Install the right rear fuse center cover.
20. Install the rear seat.
21. Use caution while reaching in and turn the ignition switch to the ON position.
The AIR BAG indicator will flash then turn OFF.
22. Perform the SIR Diagnostic System Check if the AIR BAG warning indicator does not operate as described. Refer to Diagnostic System Check -
Restraint Systems.
