CTS V8-6.0L (2007)
Air Door Actuator / Motor: Service and Repair
Recirculation Actuator Replacement (LHD)
Recirculation Actuator Replacement (LHD)
Removal Procedure
1. Remove the air inlet assembly.
2. Disconnect the electrical connector from the recirculation actuator.
3. Remove the recirculation actuator screws (1).
4. Remove the recirculation actuator.
Installation Procedure
1. Install the recirculation actuator.
Notice: Refer to Fastener Notice.
2. Install the recirculation actuator screws (1).
Tighten the screws to 1 N.m (9 lb in).
3. Connect the electrical connector to the recirculation actuator.
4. Install the air inlet assembly.
