CTS V8-6.0L (2007)
7. Remove the shift control boot and adaptor plate assembly from the vehicle.
Installation Procedure
1. Install the shift control boot and adaptor plate assembly to the vehicle.
Notice: Refer to Fastener Notice.
2. Install the 4 nuts (1) securing the shift control adaptor plate to the tunnel reinforcement.
Tighten the nuts to 12 N.m (106 lb in).
3. Lift up on the shift control lever to bring the shift control assembly in contact with the shift control adaptor plate.
4. Install the 2 bolts (2) securing the shift control assembly to the shift control adaptor plate.
Tighten the bolts to 18 N.m (13 lb ft).
