CTS V8-6.0L (2007)
22. Install the propeller shaft coupler (1) to the transmission flange.
23. Install the exhaust system.
24. Connect the shift linkage to the transmission manual shift shaft.
25. Install the transmission manual shift shaft nut.
Tighten the nut to 15 N.m (11 lb ft).
26. Adjust the shift control linkage. Refer to Shift Control Linkage Adjustment.
27. Lower the vehicle.
Important: It is recommended that transmission adaptive pressure (TAP) information be reset.
Resetting the TAP values using a scan tool will erase all learned values in all cells. As a result, The ECM, PCM or TCM will need to
relearn TAP values. Transmission performance may be affected as new TAP values are learned.
28. Reset the TAP values. Refer to Transmission Adaptive Functions.
Manual Shift Shaft Position Switch Replacement
Tools Required
J 44767 Seal Installer
Removal Procedure
1. Raise and support the vehicle. Refer to Vehicle Lifting.
2. Remove the transmission manual shift shaft nut.
3. Disconnect the shift linkage from the transmission manual shift shaft.
4. Remove the exhaust system.
