CTS RWD V6-3.6L (2008)
*
Program Key Fob 4
8. After making the selection, a beep should be heard. If a beep is not heard or the DIC displays ELECTRONIC KEY NOT DETECTED, a valid
transmitter was not found. Ensure that a valid transmitter has been placed in the cupholder and repeat step 4.
9. The scan tool will be displaying the current transmitter programming status. Press the PROGRAM soft key on the scan tool to continue with
programming. The DIC should respond by displaying: READY TO LEARN ELECTRONIC KEY #X (X = 1, 2, 3 or 4, depending on the selected
position).
10. With the DIC displaying the correct transmitter position that is to be programmed, place the new/replacement transmitter in the console pocket
with the buttons facing forward.
11. A beep will occur once the transmitter has been learned.
12. Depending on the option chosen above, the DIC may display a prompt asking that another transmitter be programmed. If programming additional
transmitters, repeat steps 9 and 10, or press the EXIT soft key on the scan tool.
Important: Newly programmed transmitters will not function until program mode has been exited (DIC is blank). This must be done
prior to pressing the UNLOCK button in the next step.
13. Press the UNLOCK button on each transmitter that was programmed to finalize the programming and confirm system operation.
