CTS RWD V6-3.6L (2008)
*
Front Brake Caliper Overhaul (See: Disc Brake System/Brake Caliper/Service and Repair/Overhaul/Front Brake Caliper Overhaul)or
Front Brake Caliper Replacement (RWD) (See: Disc Brake System/Brake Caliper/Service and Repair/Removal and Replacement/Front
Brake Caliper Replacement (RWD))Front Brake Caliper Replacement (AWD) ()
*
Rear Brake Caliper Overhaul (See: Disc Brake System/Brake Caliper/Service and Repair/Overhaul/Rear Brake Caliper Overhaul)or Rear
Brake Caliper Replacement (See: Disc Brake System/Brake Caliper/Service and Repair/Removal and Replacement/Rear Brake Caliper
Replacement)
*
Brake Pressure Modulator Valve Replacement (See: Antilock Brakes / Traction Control Systems/Hydraulic Control Assembly - Antilock
Brakes/Service and Repair)
4. If the brake fluid was NOT contaminated with an oil-based or a silicone-based substance, but WAS contaminated with water or dirt, rust,
corrosion, and/or brake dust, replace the brake master cylinder reservoir cap diaphragm which may have allowed the moisture or particles to enter
the hydraulic system.
5. Fill the brake master cylinder reservoir to the maximum-fill level with Delco Supreme 11(R) (GM P/N 12377967) or equivalent DOT-3 brake
fluid from a clean, sealed brake fluid container.
6. Pressure bleed the hydraulic brake system; begin the procedure with the pressure bleeder reservoir filled to the maximum-fill level with the correct
brake fluid as indicated. Refer to Hydraulic Brake System Bleeding (Manual) (See: )Hydraulic Brake System Bleeding (Pressure) (See: ) .
