CTS RWD V6-3.6L (2008)
12. Connect the secondary BPMV inlet brake pipe fitting (1).
Tighten the brake pipe fitting to 32 N.m (24 lb ft).
13. Install the RH front compartment sight shield. Refer to Front Compartment Sight Shields Replacement (See: Body and Frame/Spoilers, Flaps, and
Air Dams/Air Dam/Service and Repair/Front Compartment Sight Shields Replacement) .
14. Connect the negative battery cable. Refer to Battery Negative Cable Disconnection and Connection (Side Post) (See: Starting and
Charging/Battery/Battery Cable/Service and Repair) .
15. Bleed the hydraulic brake system. Refer to Hydraulic Brake System Bleeding (Manual) (See: Brake Bleeding/Service and Repair)Hydraulic Brake
System Bleeding (Pressure) (See: Brake Bleeding/Service and Repair) .
16. Perform the Antilock Brake System Automated Bleed Procedure (See: Brake Bleeding/Service and Repair) .
17. Perform the Diagnostic System Check - Vehicle (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic System
Check - Vehicle) .
