CTS RWD V6-3.6L (2008)
14. If a new park brake pedal assembly is being installed, the cable tension set pin has to be removed to set the cable tension.
15. To set the park brake cable tension, rotate the pin (1) forward then rotate the pin to the left.
16. Remove the pin.
17. Apply the park brake pedal (2) 3 full cycles to complete the tension set.
18. Install the driver knee bolster. Refer to Driver Knee Bolster Replacement (See: Body and Frame/Interior Moulding / Trim/Dashboard / Instrument
Panel/Service and Repair) .
19. Install the left instrument panel side trim panel. Refer to Instrument Panel Side Trim Panel Replacement (See: Body and Frame/Interior Moulding
/ Trim/Dashboard / Instrument Panel/Service and Repair) .
20. Install the left instrument panel insulator panel. Refer to Instrument Panel Insulator Replacement - Left Side (See: Body and Frame/Interior
Moulding / Trim/Dashboard / Instrument Panel/Service and Repair) .
