CTS RWD V6-3.6L (2008)
Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners
requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use
paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint
clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid
damage to parts and systems.
5. Tighten the exhaust camshaft position actuator bolt.
Tighten the bolt to 58 Nm (43 lb ft).
6. Install the left intake and exhaust camshaft position actuator solenoids. See: Actuators and Solenoids - Engine/Variable Valve Timing
Solenoid/Service and Repair
7. Install the left intake and exhaust camshaft position sensors. See: Powertrain Management/Computers and Control Systems/Camshaft Position
Sensor/Service and Repair
8. Install the left camshaft cover. See: Cylinder Head Assembly/Valve Cover/Service and Repair
9. On LLT engines, remove the intake manifold. See: Intake Manifold/Service and Repair
10. On LY7 engines, install the lower intake manifold. See: Intake Manifold/Service and Repair
