CTS RWD V6-3.6L (2008)
10. Install the power steering gear inlet pipe bracket bolt (1).
Tighten the bolt to 22.5 N.m (17 lb ft).
11. Connect the power steering gear inlet hose fitting (1) to the power steering pump.
Tighten the fitting to 38 N.m (28 lb ft).
12. Connect the lower control arms to the steering knuckles. Refer to Lower Control Arm Replacement (AWD) (See: Steering and
Suspension/Suspension/Control Arm/Service and Repair/Front Suspension)Lower Control Arm Replacement (RWD) (See: Steering and
Suspension/Suspension/Control Arm/Service and Repair/Front Suspension) .
13. Connect the steering linkage outer tie rods to the steering knuckles. Refer to Steering Linkage Outer Tie Rod Replacement (with Rear Wheel
Drive) (See: Steering and Suspension/Steering/Tie Rod/Service and Repair/Steering Linkage Outer Tie Rod Replacement (with Rear Wheel
Drive))Steering Linkage Outer Tie Rod Replacement (with All Wheel Drive) (See: Steering and Suspension/Steering/Tie Rod/Service and
Repair/Steering Linkage Outer Tie Rod Replacement (with All Wheel Drive)) .
14. Connect the lower intermediate steering shaft to the steering gear. Refer to Lower Intermediate Steering Shaft Replacement (See: Steering and
Suspension/Steering/Steering Column/Service and Repair/Lower Intermediate Steering Shaft Replacement) .
