CTS RWD V6-3.6L (2008)
Notice: In order to prevent any possible electrostatic discharge damage to the ECM, do not touch the connector pins.
5. Connect and lock the engine wiring harness electrical connectors (1) to the ECM (2).
6. Connect the negative battery cable. Refer to Battery Negative Cable Disconnection and Connection (Side Post) (See: Starting and
Charging/Battery/Battery Cable/Service and Repair) .
7. Program the ECM, if required. Refer to Control Module References (See: Testing and Inspection/Programming and Relearning) .
8. Turn OFF the ignition for a least 5 seconds after the programming event is complete.
