CTS RWD V6-3.6L (2008)
Camshaft Position Sensor: Service and Repair
Camshaft Position Sensor Replacement - Bank 2 (Left Side) Intake (LY7) VIN 7 W/O Direct Fuel
Injection
Camshaft Position Sensor Replacement - Bank 2 (Left Side) Intake (LP1, LY7)
Removal Procedure
1. Turn the ignition OFF.
Important: Do not disconnect the power steering fluid lines/hoses from the reservoir.
2. Remove the power steering fluid reservoir bolts and reposition the power steering fluid reservoir in order to provide access. Refer to Remote
Power Steering Fluid Reservoir Replacement (See: Steering and Suspension/Steering/Power Steering/Power Steering Fluid Reservoir/Service and
Repair) .
3. Remove the camshaft position (CMP) sensor electrical connector.
4. Remove the CMP sensor bolt.
5. Remove the CMP sensor.
Installation Procedure