CTS RWD V6-3.6L (2008)
Battery Current Sensor: Service and Repair
Battery Current Sensor Replacement
Removal Procedure
1. Disconnect the instrument panel (I/P) harness electrical connector (1) from the battery current sensor.
2. Remove the negative battery cable. Refer to Battery Negative Cable Replacement (LY7) (See: Battery/Battery Cable/Negative/Service and Repair
) .
3. Cut the tie straps and electrical tape attaching the battery current sensor to the battery cable.
4. Squeeze the negative battery cable branches together.
Important: Note the position of the battery current sensor prior to removal.
5. Slide the battery current sensor (1) off of the negative battery cable.
Installation Procedure