CTS RWD V6-3.6L (2008)
2. Install the nut securing the starter heat shield bracket to the engine block.
Tighten the nut to 8 N.m (71 lb in).
3. Install the starter heat shield bracket to the stud located at the rear of the starter motor.
4. Install the nut securing the starter heat shield bracket to the starter.
Tighten the nut to 8 N.m (71 lb in).
5. Position the starter heat shield to the starter motor and brackets.
6. Install the bolt/nuts securing the starter heat shield to the starter motor and brackets.
Tighten the bolt/nuts to 8 N.m (71 lb in).
7. Install the right catalytic converter. Refer to Catalytic Converter Replacement - Right Side (See: Engine, Cooling and Exhaust/Exhaust
System/Catalytic Converter/Service and Repair/Catalytic Converter Replacement - Right Side) .
8. Connect the battery negative cable. Refer to Battery Negative Cable Disconnection and Connection (Side Post) (See: Battery/Battery
Cable/Service and Repair) .
