CTS RWD V6-3.6L (2008)
Tighten the bolts to 50 N.m (37 lb ft).
3. Connect the power steering gear inlet hose fitting to the power steering pump.
Tighten the fitting to 38 N.m (28 lb ft).
4. Connect the power steering fluid reservoir outlet hose to the power steering pump.
5. Clean any excess fluid from the vehicle and remove the drain pans.
6. Install the power steering pump pulley. Refer to Power Steering Pump Pulley Replacement (See: ) .
7. Install the front air deflector. Refer to Front Air Deflector Replacement (See: Body and Frame/Spoilers, Flaps, and Air Dams/Air Dam/Service
and Repair/Front Air Deflector Replacement) .
8. Fill and bleed the power steering system. Refer to Power Steering System Bleeding (See: Power Steering Bleeding/Service and Repair) .
