CTS RWD V6-3.6L (2008)
Important: Note the number of complete turns made to remove the steering linkage outer tie rod.
5. Remove the steering linkage outer tie rod from the steering linkage inner tie rod.
Installation Procedure
Important: Install the steering linkage outer tie rod the same number of complete turns needed to remove it.
1. Install the steering linkage outer tie rod to the steering linkage inner tie rod. Do not tighten the steering linkage inner tie rod nut at this time.
2. Connect the steering linkage outer tie rod to the steering knuckle.
Notice: Refer to Fastener Notice (See: Service Precautions/Vehicle Damage Warnings/Fastener Notice) .
3. Install the new steering linkage outer tie rod nut.
Tighten the nut to 55 N.m (41 lb ft).
