CTS RWD V6-3.6L (2008)
4. Install the upper control arm to steering knuckle.
5. Install the upper control arm to steering knuckle pinch bolt and nut.
Tighten the nut to 60 N.m (44 lb ft).
Important: Apply threadlocker 242 or equivalent to the threads of the stabilizer shaft link.
6. Connect the stabilizer shaft link to the lower control arm.
7. Install the stabilizer shaft link retaining nut.
Tighten the nut to 50 N.m (37 lb ft).
8. Connect the outer tie rod to the steering knuckle.
9. Install the outer tie rod retaining nut.
Tighten the nut to 75 N.m (55 lb ft).
10. Install the wheel bearing/hub. Refer to Front Wheel Bearing and Hub Replacement (AWD) (See: Wheel Bearing/Service and Repair/Front
Suspension)Front Wheel Bearing and Hub Replacement (RWD) (See: Wheel Bearing/Service and Repair/Front Suspension) .
11. Install the tire and wheel. Refer to Tire and Wheel Removal and Installation (See: Wheels and Tires/Service and Repair) .
12. Lower the vehicle.
