CTS RWD V6-3.6L (2008)
Stabilizer Bushing: Service and Repair
Front Suspension
Stabilizer Shaft Insulator Replacement (AWD )
Stabilizer Shaft Insulator Replacement (AWD )
Removal Procedure
1. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle (See: Wheels and Tires/Vehicle Lifting/Service and Repair) .
2. Remove the tires and wheels. Refer to Tire and Wheel Removal and Installation (See: Wheels and Tires/Service and Repair) .
3. Remove stabilizer shaft link to stabilizer shaft retaining nut.
4. Separate the stabilizer shaft link from the stabilizer shaft.
5. Remove the stabilizer shaft bracket mounting bolts.
6. Remove the stabilizer shaft bracket.
7. Remove the stabilizer shaft insulator. Note the position of the Insulator for installation.
Installation Procedure
1. Install the stabilizer shaft insulator to the stabilizer shaft with the slit facing rearward.
2. Install the stabilizer shaft bracket.
Notice: Refer to Fastener Notice (See: Service Precautions/Vehicle Damage Warnings/Fastener Notice) .
3. Install the stabilizer shaft bracket mounting bolts.
Tighten the bolts to 110 N.m (81 lb ft).