CTS RWD V6-3.6L (2008)
7. Remove the shock absorber upper retaining nut.
8. Remove the shock absorber from the shock module.
9. Loosen the compressor forcing screw until the upper mounting plate and coil spring may be removed.
10. Remove the upper control arm bracket assembly, insulator and coil spring from the spring compressor.
Installation Procedure
Important: Ensure the alignment pins in the upper control arm bracket is orientated 90 degrees with the shock absorber lower mounting
holes.
1. Install the coil spring, insulator, upper control arm bracket assembly, and shock absorber to the spring compressor aligning all marks.
2. Turn the spring compressor forcing screw (1) until the coil spring is compressed.
Notice: Refer to Fastener Notice (See: Service Precautions/Vehicle Damage Warnings/Fastener Notice) .
3. Install the shock absorber retaining nut.
Tighten the nut to 25 N.m (18 lb ft).
