CTS RWD V6-3.6L (2008)
11. Before crimping the clamp (2), position the clamp between the bolts and washers (1), as shown, to allow for the bolt installation and removal.
12. Inspect the boot for the proper shape. If the boot is not shaped correctly, equalize the pressure in the boot by lifting the boot edge slightly and
reshape the boot properly by hand.
13. Inspect the boot for damage. If the boot was damaged during assembly, replace the boot.
Important: The boot retaining clamp must not be over-tightened or under tightened.
14. Using the J 42572 (1), crimp the large boot clamp.
Tighten the large boot clamp until the base of the clamp has a gap of 1 mm (0.039 in).
15. Using an alcohol based solvent, remove any grease or sealant from the cap for the inner joint and allow to air dry.
16. Place a 3 mm (0.118 in) bead of sealant, GM P/N 88861422 (Canadian P/N 88861422) or equivalent, on the inside diameter of the joint face
assembly.
