CTS RWD V6-3.6L (2008)
Important: Install the seal onto the tool before installing into the case to prevent damage to the seal.
3. Using J 44765 install the new transmission case extension seal (1).
4. Install the drive flange (2) to the transmission output shaft.
5. Install a NEW drive flange fluid seal (3).
6. Install a NEW drive flange nut (4) until finger tight.
Preload Adjustment Procedure
1. Shift the transmission into any gear.
2. Attach DT-48636 to the output flange.
3. Hold DT-48636 in order to prevent the output flange from rotating. Using J 29873 tighten the output flange nut. Tighten until the looseness is
minimal.
