CTS RWD V8-6.2L SC (2009)
When installed to the seat adjuster track, the rear finish covers are engaged at the locations noted on the underside view above:
-
The two rearward finish cover clips (1) are engaged to the adjuster track.
-
The forward finish cover hook (2) is engaged in the slot in the adjuster lower bracket.
To remove the front seat adjuster track front finish covers:
1. Disengage the outboard side of the cover by pulling it outward, flexing the cover tab away from the adjuster hook.
2. When the tab is clear of the hook, pull the front of the cover up and forward to release it from the front of the adjuster rail.
3. After the front tab comes free, then disengage the hook on the inboard side of the cover.
Tip
Use the same method to remove the opposite side.
To remove the front seat adjuster track rear finish covers:
1. Disengage the two rear cover clips by prying the cover upward from the rear of the cover.
2. When the clips are free from the adjuster track, pull the cover rearward to disengage the hook from the adjuster lower bracket.
Tip
Use the same method to remove the opposite side.
Disclaimer
