CTS RWD V8-6.2L SC (2009)
12. Remove the intermediate brake hose assembly mounting nuts (1) from the studs.
13. Remove the intermediate brake hose assembly (2) from the vehicle.
Installation Procedure
Caution: Make sure the brake hose is not twisted or kinked after installation. Damage to the hose could result.
1. Install the intermediate brake hose assembly (2) to the mounting studs.
Caution: Refer to Fastener Caution (See: Service Precautions/Vehicle Damage Warnings/Fastener Caution).
2. Install the intermediate brake hose assembly mounting nuts (1) to the mounting studs and tighten to 10 Nm (89 lb in).
3. Connect the 2 brake pipe fittings to the intermediate brake hose assembly.
4. Remove the plug from the brake caliper inlet port.
Note: Install NEW copper brake hose gaskets.
