CTS RWD V8-6.2L SC (2009)
8. Install the oil pan-to-front cover bolts until snug.
9. Install the EN-47812 over the bolt to the crankshaft.
10. Install the EN-47813 .
11. Insert the tapered surface of the tool into the oil seal bore of the cover EN-47812 washer and nut.
Tighten the nut by hand until snug. Do not overtighten. Tighten the engine front cover bolts to 30 Nm (22 lb ft).
12. Remove the tools.
13. Install a NEW crankshaft front oil seal. Refer to Crankshaft Front Oil Seal Installation (See: Service and Repair/Overhaul).
14. Install the valve lifters. Refer to Valve Lifter Installation (See: Service and Repair/Overhaul).
15. Install the right and left cylinder heads. Refer to Cylinder Head Installation - Right Side (See: Service and Repair/Overhaul) and Cylinder Head
Installation - Left Side (See: Service and Repair/Overhaul).
16. Install the valve rocker arms and push rods. Refer to Valve Rocker Arm and Push Rod Installation (See: Service and Repair/Overhaul).
17. Install the right and left valve rocker arm covers. Refer to Valve Rocker Arm Cover Installation - Right Side (See: Service and Repair/Overhaul)
and Valve Rocker Arm Cover Installation - Left Side (See: Service and Repair/Overhaul).
18. Install the supercharger. Refer to Supercharger Installation (See: Service and Repair/Overhaul).
19. Install the water pump. Refer to Water Pump Installation (See: Service and Repair/Overhaul).
20. Install the left and right exhaust manifolds. Refer to Exhaust Manifold Installation - Left Side (See: Service and Repair/Overhaul) and Exhaust
Manifold Installation - Right Side (See: Service and Repair/Overhaul).
21. Install the crankshaft balancer. Refer to Crankshaft Balancer Installation (See: Service and Repair/Overhaul).
22. Install the engine assembly. Refer to Engine Replacement (See: Service and Repair/Removal and Replacement).
