CTS RWD V8-6.2L SC (2009)
Installation Procedure
1. Install the recirculation actuator.
Caution: Refer to Fastener Caution (See: Service Precautions/Vehicle Damage Warnings/Fastener Caution).
2. Install the recirculation actuator screws (1) and tighten to 1 Nm (9 lb in).
3. Connect the electrical connector to the recirculation actuator.
4. Install the air inlet assembly. Refer to Air Inlet Assembly Replacement (Right Hand Drive) (See: Air Duct/Service and Repair/Air Inlet Assembly
Replacement (Right Hand Drive))Air Inlet Assembly Replacement (Left Hand Drive) (See: Air Duct/Service and Repair/Air Inlet Assembly
Replacement (Left Hand Drive)).