CTS RWD V8-6.2L SC (2009)
Note: Use special anti-seize compound on the HO2S threads. The compound consists of graphite suspended in fluid and glass beads. The graphite
burns away, but the glass beads remain, making the sensor easier to remove. New or service sensors already have the compound applied to the
threads. If you remove an oxygen sensor and if for any reason you must reinstall the same oxygen sensor, apply the anti-seize compound to the
threads before reinstallation.
1. Coat the threads of the HO2S with the anti-seize compound P/N 5613695, or the equivalent if necessary.
Caution: Refer to Fastener Caution (See: Service Precautions/Vehicle Damage Warnings/Fastener Caution).
2. Install the HO2S (1) and tighten to 41 Nm (30 lb ft).
3. Connect the HO2S electrical connector.
4. Route and attach the wire harness as noted during disassembly.
5. Lower the vehicle.
