CTS RWD V8-6.2L SC (2009)
For step-by-step programming instructions, please refer to SI and the Techline Information System (TIS) terminal.
1.
Verify that there is a battery charge of 12 to 16 volts. The battery must be able to maintain a charge during programming. Only use an approved
Midtronic 165-PSC charger to maintain proper battery voltage during programming.
Caution:
To avoid personal injury or part damage, it is essential to determine if the vehicle is equipped with RPO KA1. USE the GM VEHICLE
INQUIRY SYSTEM (GMVIS) to determine if the vehicle is equipped with RPO KA1. There are two calibration options available for the
passenger presence system. One calibration is for vehicles without RPO KA1 and the other is for vehicles with RPO KA1. Select the
appropriate calibration from the Calibration screen.
2.
Reprogram the passenger presence system (PPS). Refer to SI and Service Programming System (SPS) documentation for programming
instructions, if required.
3.
Using the Tech 2, navigate to the PPS Module Setup Screen. DTC B00814B, "Calibration not Learned," should be set. Perform PPS module
setup. Follow the Tech 2 screen instructions.
2.1.
Connect the MDI or Tech 2(R) to the vehicle.
Important:
Select J2534 MDI or J2534 Pass-Thru and Reprogram ECU from the Select Diagnostic Tool and Programming Process screen. The J2534
MDI will reprogram the module in less time than the Tech 2(R) scan tool.
2.2.
Select PPS Passenger Presence System from the Supported Controllers screen.
2.3.
Follow the on-screen instructions.
3.
Using the Tech 2, navigate to the PPS Module Setup Screen. DTC B00814B, "Calibration not Learned," should be set. Perform PPS module
setup. Follow the Tech 2 screen instructions.
4.
Using the Tech 2(R), clear all DTCs.
Courtesy Transportation - For US and Canada
The General Motors Courtesy Transportation program is intended to minimize customer inconvenience when a vehicle requires a repair that is covered
by the New Vehicle Limited Warranties. The availability of courtesy transportation to customers whose vehicles are within the warranty coverage period
and involved in a product program is very important in maintaining customer satisfaction. Dealers are to ensure that these customers understand that
shuttle service or some other form of courtesy transportation is available and will be provided at no charge. Dealers should refer to the General Motors
Service Policies and Procedures Manual for Courtesy Transportation guidelines.
Claim Information
Submit a Product Recall Claim with the information shown above.
Customer Notification - For US and Canada
General Motors will notify customers of this recall on their vehicle (see copy of customer letter shown in this bulletin).
