CTS RWD V8-6.2L SC (2009)
1. Reconnect electrical connector (3) for the engine harness to the knock sensor (2).
2. Position the knock sensor (2) on the engine block (5).
3. Install the mounting bolt (1) for the knock sensor (2).
Caution: Refer to Fastener Caution (See: Service Precautions/Vehicle Damage Warnings/Fastener Caution).
4. Tighten the knock sensor mounting bolt (1) and tighten to 20 Nm (15 lb ft).
5. Install the starter assembly (4), ONLY IF REMOVED. Refer to Starter Replacement (SFI) (See: Starting and Charging/Starting System/Starter
Motor/Service and Repair)Starter Replacement (V8) (See: Starting and Charging/Starting System/Starter Motor/Service and Repair).
6. Install the right catalytic convertor. Refer to Catalytic Converter Replacement - Right Side (V6) (See: Engine, Cooling and Exhaust/Exhaust
System/Catalytic Converter/Service and Repair)Catalytic Converter Replacement - Right Side (V8) (See: Engine, Cooling and Exhaust/Exhaust
System/Catalytic Converter/Service and Repair).
7. Install the right exhaust manifold. Refer to Exhaust Manifold Replacement - Right Side (V6) (See: Engine, Cooling and Exhaust/Exhaust
System/Exhaust Manifold/Service and Repair/Exhaust Manifold Replacement - Right Side)Exhaust Manifold Replacement - Right Side (V8) (
See: Engine, Cooling and Exhaust/Exhaust System/Exhaust Manifold/Service and Repair/Exhaust Manifold Replacement - Right Side).
Note: Perform the following procedure only if the battery has been disconnected.
8. Program the transmitters. Refer to Transmitter Programming (without RPO Y41) (See: Testing and Inspection/Programming and Relearning
)Transmitter Programming (with RPO Y41 - North America and Asia) (See: Testing and Inspection/Programming and Relearning)Transmitter
Programming (with RPO Y41 - Canada and Europe) (See: Testing and Inspection/Programming and Relearning).
