CTS RWD V8-6.2L SC (2009)
7. Using the J 41099 , remove the reverse lockout solenoid.
8. Remove the bolt and the reverse lockout assembly , if necessary.
Installation Procedure
1. If removed, inspect the reverse lockout assembly O-ring. Replace the reverse lockout assembly O-ring if necessary.
Caution: Refer to Fastener Caution (See: Service Precautions/Vehicle Damage Warnings/Fastener Caution).
2. Install the reverse lockout assembly and bolt and tighten to 18 Nm (13 lb ft).
3. Install the reverse lockout solenoid using the J 41099 . Inspect and replace the O-ring if necessary.
Tighten the reverse lockout solenoid to 40 Nm (30 lb ft).