CTS RWD V8-6.2L SC (2009)
4. Using the DT 47784 - fluid fill pan adapter (1), J 45096-30 - cooler flush adapters (2), and the J 45096 - flush and flow test tool (3), add
transmission fluid through the check plug hole. Refer to Transmission Fluid Cooler Flushing and Flow Test (See: Testing and
Inspection/Transmission Fluid Cooler Flushing and Flow Test) for complete J 45096 operating instructions. Use the FLOW position on the main
function switch to pump the fluid.
Note: Failure to start the engine and move the shift lever through the gear ranges before removing the DT 47784 - fluid fill pan adapter and J
45096-30 - cooler flush adapters from the bottom pan will result in an excess amount of fluid draining from the check plug hole. This may lead to
an under-fill condition.
5. Start the engine and move the shift lever through each gear range. Pause for at least 3 seconds in each gear range.
6. With the engine still running, remove the DT 47784 - fluid fill pan adapter (1), (2), and J 45096 - flush and flow test
tool (3) and then check the fluid level. Refer to Transmission Fluid Check (See: Testing and Inspection/Component Tests and General
Diagnostics/Transmission Fluid Check).
