CTS RWD V8-6.2L SC (2009)
Differential Mount: Service and Repair
Differential Housing Support Bushing Replacement (Rear)
Differential Housing Support Bushing Replacement (Rear)
Special Tools
DT-48060-A Bushing Remover/Installer
Removal Procedure
1. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle (See: Maintenance/Vehicle Lifting/Service and Repair).
2. Remove the rear differential assembly. Refer to Differential Replacement (See: Service and Repair/Removal and Replacement/Differential
Replacement).
Important: Apply a small amount of clean grease or oil the thread of the DT-48060-A .
Important: Check the bore of the support bushing for damage, cracks, etc,. If any damage is found, replace the rear differential.
3. Using the DT-48060-A remove the rear differential housing support bushing.
Installation Procedure.
1. Remove any dirt or debris from the support bushing bore.
2. Position the rear support bushing in the bore.
