CTS RWD V8-6.2L SC (2009)
5. Using a pair of snap ring pliers, install the new retaining ring (1) for the CV joint.
Note: Ensure that all of the internal components are lubricated.
6. Apply the remaining lubricant in the ball bearings and the cage of the CV joint.
7. Before crimping the clamp (2), position the clamp between the bolts and washers (1) to allow for the bolt installation and removal.
8. Inspect the boot for the proper shape. If the boot is not shaped correctly, equalize the pressure in the boot by lifting the boot edge slightly and
reshape the boot properly by hand.
9. Inspect the boot for damage. If the boot was damaged during assembly, replace the boot.
