CTS RWD V8-6.2L SC (2009)
10. Using the J 42572 - pliers (1), close the inner and outer boot clamps until the gap (a) in the clamp measures 1.0 (0.040 in).
11. Using an alcohol based solvent, remove any lubricant or sealant from the cap and allow to air dry.
12. Apply a 3 mm (0.118 in) on the inside diameter of the of the CV joint face. Refer to Adhesives, Fluids, Lubricants, and Sealers (See:
Specifications/Fluid Type Specifications).
Note: Align the holes for the mounting fasteners in the cap and the CV joint.
13. Using the J 22928-B - installer (1), install the CV joint cap (2).
14. Rotate the inner joint 4 or 5 times in a circular motion to distribute the lubricant and check the operation of the joint.
15. Remove any excess lubricant from the wheel drive shaft assembly.
16. Install the wheel drive shaft. Refer to Rear Wheel Drive Shaft Replacement (See: Service and Repair/Rear Wheel Drive Shaft Replacement).
