CTS RWD V8-6.2L SC (2009)
30. Insert the remaining grease from the service kit into the seal.
31. Position the small seal retaining clamp (2) into the boot groove.
32. Position the boot and small retaining clamp to the axle shaft boot groove (3) as shown.
Caution: Refer to Fastener Caution (See: Service Precautions/Vehicle Damage Warnings/Fastener Caution).
Note: The seal retaining clamp must not be over-tightened or under-tightened.
33. Using the J 42572 , crimp the small seal retaining clamp and tighten until there is a gap of 1 mm (0.039 in) (1).
