CTS RWD V8-6.2L SC (2009)
2. Install the rear extension housing (86). Refer to Transmission Assemble (See: Service and Repair/Overhaul/Aisin AY6 - Manual
Transmission/Assembly/Transmission Assemble).
Note: Install the seal onto the tool before installing into the case to prevent damage to the seal.
3. Using J 44765 install the new transmission case extension seal (1).
4. Install the drive flange (2) to the transmission output shaft.
5. Install a NEW drive flange fluid seal (3).
6. Install a NEW drive flange nut (4) until finger tight.
Preload Adjustment Procedure
