CTS RWD V8-6.2L SC (2009)
Seals and Gaskets: Service and Repair
Tremec 6-Speed - Manual Transmission
Mainshaft Rear Oil Seal Replacement
Special Tools
*
J 6125-1B Slide Hammer
*
J 23129 Universal Seal Remover
*
J 29873 Injector Nozzle Socket 30 mm
*
J 44765 Seal Installer
*
J 45012 Holding Fixture
*
J 45019 Flange and Pinion Gage Remover
Removal Procedure
1. Place the transmission in neutral.
2. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle (See: Maintenance/Vehicle Lifting/Service and Repair).
3. Remove the propeller shaft (6). Refer to Rear Propeller Shaft Replacement (RPO LP1/LY7) (See: Drive/Propeller Shafts, Bearings and
Joints/Drive/Propeller Shaft/Service and Repair)Rear Propeller Shaft Replacement (RPO LSA) (See: Drive/Propeller Shafts, Bearings and
Joints/Drive/Propeller Shaft/Service and Repair).
4. Install the J 45012 to the drive flange.
5. While holding the J 45012 , remove the flange nut using the J 29873 .
6. Remove the J 45012 .