CTS Sedan AWD V6-3.0L (2010)
9. Separate the instrument panel plastic retainer (2) from the magnesium beam (1).
1. Carefully insert a piece of wood (or equivalent) that is 165 mm (6.5 in) in length between the instrument panel plastic retainer (1) and the
frame (2) as shown in the illustration.
2. Insert a screwdriver, or equivalent, between the front center section of the magnesium beam and the instrument panel plastic retainer as shown
to hold the instrument panel plastic retainer away from the magnesium beam.
3. Using a pen, mark a cut line on the inboard side of the end cinch nuts (1). Refer to the illustration. The cut lines should be as close to the cinch
nuts as possible.
4. Ensure that the instrument panel plastic retainer (4) is separated from the magnesium beam (3).
