CTS Sedan AWD V6-3.0L (2010)
2. Ensure that the alignment pin on the rear of the tensioner assembly is aligned with the locating hole on the engine.
Caution: Refer to Fastener Caution (See: Service Precautions/Vehicle Damage Warnings/Fastener Caution).
3. Install the drive belt tensioner bolt and tighten to 50 Nm (37 lb ft).
4. Install the generator and water pump drive belt. Refer to Water Pump and Generator Belt Replacement (See: Drive Belt/Service and
Repair/Water Pump and Generator Belt Replacement).
