CTS Sedan AWD V6-3.0L (2010)
8. Position the intake manifold brace.
9. Install the intake manifold brace bolts (1) and tighten to 23 Nm (17 lb ft).
Caution: Ensure proper engagement of the wiring harness connector. The wiring harness connector must be installed straight onto the component
connector and firmly seated. Visually inspect the connector to ensure that the connector latches are engaged and locked. Any damage to the
connector or wiring must be repaired. Failure to follow this procedure can lead to an intermittent electrical connection, driveability concerns,
and/or wiring harness or wiring harness connector damage or failure.
10. Connect the electrical connector (2) to the throttle body.
11. Install the throttle body harness electrical harness retainer (1).
