CTS Sedan AWD V6-3.0L (2010)
13. Connect the intermediate shaft to the power steering gear. Refer to Steering Gear Replacement (Left Hand Drive With All Wheel Drive) (See:
Steering and Suspension/Steering/Steering Gear)Steering Gear Replacement (Left Hand Drive With Rear Wheel Drive) (See: Steering and
Suspension/Steering/Steering Gear)Steering Gear Replacement (Right Hand Drive) (See: Application and ID).
14. Align the torque converter to flexplate/flywheel orientation marks made during the removal procedure.
Note: Torque converter bolts are self locking and must be replaced with NEW torque converter bolts every time the bolts are removed.
15. Complete the following steps for all torque converter bolts (1):
1. Rotate the harmonic balancer center bolt clockwise ONLY, in order to align the torque converter bolt holes in the flexplate/flywheel with the
access hole in the engine block.
2. To aid in alignment of the torque converter to the flexplate/flywheel. Install all NEW torque converter bolts (1) before fully tightening to 63
Nm (46 lb ft).
