CTS Sedan AWD V6-3.0L (2010)
20. Install the transmission vent hose to the retaining clips (6) on the transmission mount assembly.
21. Install the wiring harness retainers (4) to the transmission.
22. Connect the transmission wiring harness connector (5) to the transmission by rotating the locking latch clockwise.
23. Install the oxygen sensor wiring harness retainer to the transmission.
24. Install the shift linkage to the transmission.
25. Install the transmission manual shift shaft nut and tighten to 15 Nm (11 lb ft).
26. Install the front and rear propeller shafts. Refer to Front Propeller Shaft Replacement (See: Transmission and Drivetrain/Drive/Propeller Shafts,
Bearings and Joints/Drive/Propeller Shaft/Service and Repair/Front Propeller Shaft Replacement) and Rear Propeller Shaft Replacement (RPO
LSA) (See: Transmission and Drivetrain/Drive/Propeller Shafts, Bearings and Joints/Drive/Propeller Shaft/Service and Repair)Rear Propeller
Shaft Replacement (RPO LLT/LF1with MX7 or MN6) (See: Transmission and Drivetrain/Drive/Propeller Shafts, Bearings and
Joints/Drive/Propeller Shaft/Service and Repair)Rear Propeller Shaft Replacement (RPO LLT, LF1 with MXO) (See: Transmission and
Drivetrain/Drive/Propeller Shafts, Bearings and Joints/Drive/Propeller Shaft/Service and Repair).
27. Install the catalytic converters. Refer to Catalytic Converter Replacement - Left Side (LLT) (See: Engine, Cooling and Exhaust/Exhaust
System/Catalytic Converter/Service and Repair/Catalytic Converter Replacement - Left Side)Catalytic Converter Replacement - Left Side (LSA)
(See: Engine, Cooling and Exhaust/Exhaust System/Catalytic Converter/Service and Repair/Catalytic Converter Replacement - Left Side)Catalytic
Converter Replacement - Left Side (LF1) (See: Engine, Cooling and Exhaust/Exhaust System/Catalytic Converter/Service and Repair/Catalytic
