CTS Sedan AWD V6-3.0L (2010)
7. Remove the reverse lockout solenoid.
8. Remove the bolt and the reverse lockout assembly , if necessary.
Installation Procedure
1. If removed, inspect the reverse lockout assembly O-ring. Replace the reverse lockout assembly O-ring if necessary.
Caution: Refer to Fastener Caution (See: Service Precautions/Vehicle Damage Warnings/Fastener Caution).
2. Install the reverse lockout assembly and bolt and tighten to 18 Nm (13 lb ft).
3. Install the reverse lockout solenoid.
Tighten the reverse lockout solenoid to 40 Nm (30 lb ft).