CTS Sedan AWD V6-3.0L (2010)
34. Position the large seal retaining clamp (1) onto the seal (2).
35. Position the seal and large retaining clamp to the joint outer race (3) as shown.
Note: The seal must not be dimpled, stretched or otherwise deformed.
36. Inspect the boot for proper shape.
If the boot is not shaped correctly, equalize the pressure in the boot by lifting the boot edge slightly and shape the properly by hand.
37. Inspect the boot for damage.
If the boot has been cut or punctured during assembly, you must discard and replace the boot.
Note: The seal retaining clamp must not be over-tightened or under-tightened.
38. Using the J 42572 , crimp the large seal retaining clamp and tighten until there is a gap of 1 mm (0.039 in) (1).
The clamping hold time must be no less than 2 seconds.
39. Inspect the outer joint for smooth operation. This will also distribute the grease within the joint.
1. Hold the wheel drive shaft vertically, with the outer joint at the bottom.
2. Rotate the wheel drive shaft 4 or 5 times in a circular motion.
40. Install the wheel drive shaft. Refer to Rear Wheel Drive Shaft Replacement (See: Service and Repair)
