CTS Sedan AWD V6-3.0L (2010)
9. Use the J 6125-1B and J 23129 to remove the transmission case extension seal (1).
Installation Procedure
Note: Install the seal onto the tool before installing into the case to prevent damage to the seal.
1. Using J 44765 install the new transmission case extension seal (1).
2. Install the drive flange to the transmission output shaft.
3. Install a NEW drive flange thrust washer (2).
4. Install the J 45012 to the drive flange.
Caution: Refer to Fastener Caution (See: Service Precautions/Vehicle Damage Warnings/Fastener Caution).
5. While holding J 45012 , install a NEW drive flange nut using J 29873 .