CTS Sedan RWD V6-3.0L (2010)
12. Install the support fixture (3) in order to raise the lower control arms for ease of lower shock bolt installation (2).
13. Install the lower shock bolt (2) to 150 Nm (111 lb ft).
14. Repeat the above step for the other side.
15. Remove the support fixture (3).
16. Install the intermediate park brake cable to the body bracket.
17. Connect the intermediate park brake cable (2) to the front park brake cable connector.
18. Position the brake pipe bracket (2) to the body studs.
19. Install the brake pipe bracket retaining nuts (1) and tighten to 10 Nm (89 lb in).
20. Connect the rear brake lines (1) at the forward rear wheelhouse and tighten the lines to 15 Nm (11 lb ft).
21. Connect the rear WSS electrical connectors.
22. Secure the WSS electrical harness retainer clips to the upper control arms.
23. Install the propeller shaft. Refer to Rear Propeller Shaft Replacement (RPO LSA) (See: Transmission and Drivetrain/Drive/Propeller Shafts,
