CTS Sedan RWD V6-3.0L (2010)
7. Install the brake caliper and bracket assembly (1).
8. Install the upper brake caliper bracket bolt (1) and tighten to 135 Nm (100 lb ft).
9. Install the lower brake caliper bracket bolt (2) and tighten to 135 Nm (100 lb ft).
10. Install the tire and wheel assembly. Refer to Tire and Wheel Removal and Installation (See: Maintenance/Wheels and Tires/Service and Repair).
11. Set the electronic park brake cable tension. Refer to Parking Brake Cable Adjuster Enabling (Electric Park Brake) (See: Parking Brake
System/Parking Brake Cable/Service and Repair/Procedures/Parking Brake Cable Adjuster Enabling (Electric Park Brake)).
12. If the brake rotor was refinished or replaced, or if new brake pads were installed, burnish the pads and rotors. Refer to Brake Pad and Rotor
Burnishing (See: Brake Pad/Service and Repair/Brake Pad and Rotor Burnishing).
